View Single Post
  #83  
Old 08-01-2016, 06:27 AM
BlwnAway's Avatar
BlwnAway BlwnAway is offline
Y Rated - 186 mph
 
Join Date: Sep 2006
Location: St.Louis, Mo.
Posts: 1,988
Default

Clutch is due next weekend, so reassembly can finally start.
But in the meantime got one more project done:
Rear Seat Delete and new rear Floor Pans.
Started with a 24"x48" piece of cold rolled 18ga steel, normally I'd use aluminum or something thinner to cut weight, but I had decided to move the Bottle and W/M tank inside the cabin so the pans had to have some strength to them. Made some cardboard templates and got out the air shears, a few cuts, some grinding, a bunch of measuring and a little paint later and this is what I ended up with:
Drivers Side.

Click the image to open in full size.

Pass Side, w/ rivet nuts for Bottle brackets.

Click the image to open in full size.

Then just a little unbacked automotive carpet and some edge trim.

Click the image to open in full size.

Added a little plastic fiber foam for support.

Click the image to open in full size.

And installed.

Click the image to open in full size.

Click the image to open in full size.

Harnesses fit around the bottle perfectly.

Click the image to open in full size.
__________________
I'll get another 3rd party hosting site eventually...

Just hope the old one dies a fiery death.
But I'm not bitter....

Last edited by BlwnAway; 08-01-2016 at 06:38 AM..
Reply With Quote